Descrizione
MILEAGE FILTER FOR MERCEDES-BENZ S-CLASS FACELIFT MODEL
The Mileage Filter is a precision-engineered automotive module designed to deliver flawless mileage control during testing scenarios. Built to the highest standards, it ensures that mileage is accurately paused only when required—while all vehicle systems continue to operate seamlessly.
Created for tuning specialists, performance workshops, and motorsport professionals, the Mileage Filter allows vehicles to undergo dyno runs, diagnostics, and calibration sessions without adding unnecessary mileage. Its advanced design guarantees full compatibility and a completely reversible installation that leaves absolutely no trace upon removal.
Developed by specialists in automotive electronic systems, the Mileage Filter provides stable operation without permanent diagnostic data records, plug-and-play installation simplicity and long-term reliability.
The Mileage Filter is sometimes referred to as: Odometer Blocker, Odometer Stopper, Mileage Limiter, Mileage Blocker, Can Blocker, Mileage Stopper, Mileage Freezer, Mileage Stop, KM Limiter, KM Stopper, KM Stop, Odometer Filter, Can Filter, Can Emulator, Dyno Test Module.
⚠️ Important Notice:
The Mileage Filter is intended exclusively for testing and motorsport use on closed tracks or dyno facilities. It is not approved for use on public roads, and the seller assumes no liability for misuse.
COMPATIBLE WITH MERCEDES-BENZ S-CLASS PRODUCED 2018-2022.
Specification
- Built with ONLY genuine electronic components for superior quality and precision.
- CAN bus lines made as a twisted pair for a lossless and interference-free connection
- Uses original connectors and automotive-grade wires
- The speedometer and assist functions remain fully operational.
- Pure Plug-and-Play: installs cleanly and removes without a trace.
- Simple installation and removal
- Quick and intuitive control with simple key presses.
- Works perfectly with your dashboard – no error messages or system alerts.
- Last settings remain stored – even after power is disconnected.
- Professionally engineered by automotive electronics experts.
ACTIVATION - DEACTIVATION
Press and hold steering wheel ↩ Return button for 10 seconds.
Use the same procedure to select the next mode.
Mileage Filter remembers your last settings—no need to reconfigure it each time you start the vehicle.
1
MODE
2
MODE
RESET PROCEDURE
Connect the device to a PC using USB cable and the dedicated tool and read its unique ID. Send this ID to us to receive a RESET TOKEN.
Note: The token is valid for one-time use only.
After applying the token, the stored VIN is erased. The device can then be installed in a new vehicle, where it will store the new VIN and lock again.
Faq
Paused mileage will not increase or update later, and you can install or remove the module anytime without affecting the stored value. Some vehicles may store minor CAN interruption entries, but they are harmless and can be easily cleared with any diagnostic tool.
Recensioni
Ancora non ci sono recensioni.